04-02-2023, 05:42 PM
On my 1971 Kombi this perforated sheet above the engine was held up by large aluminum rivets. I had to drill the rivets out to remove the sheet.
When I replaced it, I used suitable gauge screws and large washers.
I found a couple of UK based suppliers that had replacement covers - but they are not cheap.
https://www.serial-kombi.com/en-GB/bay-w...79-n316485
https://bus-ok.nl/Type2-bay-Covering-the...ype1-engin
I think your 1972 Kombi has a larger engine bay configuration to my 1971 model - not sure if the roof cover sheets are the same ?
I was able to make repairs to my original perforated sheet and reuse it. I replaced the insulation above the cover and installed a BlazCut fire suppression tube below it.
Also see this thread from thesamba https://www.thesamba.com/vw/forum/viewto...p?t=171835
No help on the side cover ..sorry!
When I replaced it, I used suitable gauge screws and large washers.
I found a couple of UK based suppliers that had replacement covers - but they are not cheap.
https://www.serial-kombi.com/en-GB/bay-w...79-n316485
https://bus-ok.nl/Type2-bay-Covering-the...ype1-engin
I think your 1972 Kombi has a larger engine bay configuration to my 1971 model - not sure if the roof cover sheets are the same ?
I was able to make repairs to my original perforated sheet and reuse it. I replaced the insulation above the cover and installed a BlazCut fire suppression tube below it.
Also see this thread from thesamba https://www.thesamba.com/vw/forum/viewto...p?t=171835
No help on the side cover ..sorry!
1971 Sopru aka Doob