25-06-2023, 01:15 PM
Had a tinware moment
Needed to alter the tinware and the engine conversion plate on the 3-4 Side and the bit that meets the firewall slightly
forgot to take pictures till after it was done and the upper tinware colour matched to the van
Cylinder heads next and this will present a problem. Because of the stroker crank the combustion chambers will be too small and I want the squish area to be at or bellow 1.5mm. Rough calculation, 6cc need to come out of the head to get the compression ratio I want
Needed to alter the tinware and the engine conversion plate on the 3-4 Side and the bit that meets the firewall slightly
forgot to take pictures till after it was done and the upper tinware colour matched to the van
Cylinder heads next and this will present a problem. Because of the stroker crank the combustion chambers will be too small and I want the squish area to be at or bellow 1.5mm. Rough calculation, 6cc need to come out of the head to get the compression ratio I want