25-02-2023, 04:44 PM
(25-02-2023, 04:15 PM)rstucke Wrote: supposed to sit around the inside of the seal to supply tension on the flange
Hmmm. No stretchy spring on the seal I took out. Now I am worried as to where that could have gone. ?
I have taken the opportunity to mark the position of the large adjusting ring with a paint pen, unscrew screw it a small amount and use a hook to take out the O-ring and replace it with a fresh new one. Then screwed it back in to where it was before and a tiny fraction more. Now I have to be very patient for Mick Motors to open on Monday. (Patience is one thing I do not have much of!)