Thread Rating:
  • 3 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What did you do to your kombi today ?
I had similar a problem after changing out all the bushings and guides on the gearshift rods.  Following the Bentley Manual (as above) got me 90% there, but I had to move floor plate 'bracket' around, on a trial & error basis, to find a position that allowed all gears to be selected reliably. Reverse is normally not a problem, and moving up through the gears is fine. However changing down can be a issue sometimes - particularly going from 3rd back to 2nd. 
I notice I have some wear on the gearshift lever and the stop plate, where they interact.  Not sure if this wear is contributing to the problem ?
1971 Sopru aka Doob
Reply


Messages In This Thread
What did you do to your kombi today ? - by Oldman - 01-07-2022, 09:32 AM
RE: What did you do to your kombi today ? - by Doob - 18-12-2022, 07:44 PM
Wheel refurb - by ruby6689 - 20-12-2022, 10:52 AM
RE: Wheel refurb - by Barry - 20-12-2022, 11:45 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)