Hi Aircooled,
Bit late in the reply
To get the position of the offset retaining clips into the right place put play dough over each card pin aperture & then put card on door & thump it all the way around.
The play dough will show at what angle the eccentric clip should be placed.
Remove play dough & insert clip at the known angle.
Gets them 'centred' so there is less strain on the clip at the correct angle!
Once you get the first 6 or 8 in it's then just move around the card.
I started at the door lock pin. A couple on the horizontal & then down the rear of the door & then back up.
Worked a treat even with the bad clips .
Cheers
Bit late in the reply
To get the position of the offset retaining clips into the right place put play dough over each card pin aperture & then put card on door & thump it all the way around.
The play dough will show at what angle the eccentric clip should be placed.
Remove play dough & insert clip at the known angle.
Gets them 'centred' so there is less strain on the clip at the correct angle!
Once you get the first 6 or 8 in it's then just move around the card.
I started at the door lock pin. A couple on the horizontal & then down the rear of the door & then back up.
Worked a treat even with the bad clips
.Cheers
Yesterday is History. Tomorrow a Mystery. Today is the PRESENT.
Pilot of "Old Boy" 76 Sopru fuel injected
Copilot - Lauren
Pilot of "Old Boy" 76 Sopru fuel injected
Copilot - Lauren