01-01-2024, 07:14 PM
(01-01-2024, 07:00 PM)Wayne Murray Wrote: The panel really is for a later model, you can tell where the rubber mat curls under at the front of that panel.(top left corner of panel in photo) The earlier model like 72 doesn't have it where 76 does.
If you buy the panel plus your seat rails you can sit one over the other and make a decision on whether to cut out the whole panel or parts. It would have to fit with in reason.
Yeah, it's a bit of a pain as it's the only one available as far as I can tell. I've searched stores online all over the world and apparently it's the only repro you can buy. I have a fair range of panel forming equipment here, but that one's way beyond my skillset. I think I'll just have to bite the bullet and buy one....then chop it into small sections that I can use...
Mark