Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Engine surges
#11
(12-08-2023, 09:16 AM)Barry Wrote: So…… to close this out. 

I have been quite time poor lately, and issues with both kombis and we are leaving today for a two week holiday overseas. 

Spoke with Nils and the old one wasn’t that bad. 
But the micro switch was all gummed up. 
Apparently it has never had a cover? 
It’s underneath so you wouldn’t know looking at it. 
New one does  Big Grin
So with all that dirt driving, no wonder I had issues

The new throttle body seems to go well……….except once or twice when I kick down (I have an auto) it stuck at wide open.  
I couldn’t work out WTF was going on and my mechanic that did the work had taken off for a couple of month holiday. 
Being an auto it isn’t just a matter of undoing the accelerator cable and checking for movement in throttle body. 
Autos have this weird set up of a spring and an E circlip so I have found out. 
While scouring the internet trying to find out the best way to get it off, I came across 1 comment that said “don’t make the mistake I made where you end up with the throttle body getting stuck in the wide open position” 
It is so easy to bend the spring that goes through the lever arm a “poofteenth” that it causes it to become stuck. 

So….. there ya go. 
Who would’ve known. 
Son was that a full "poofteenth or 1/2  of one?
Reply


Messages In This Thread
Engine surges - by Barry - 19-06-2023, 09:38 AM
RE: Engine surges - by Wayne Murray - 19-06-2023, 12:04 PM
RE: Engine surges - by Barry - 19-06-2023, 12:34 PM
RE: Engine surges - by Barry - 19-06-2023, 12:51 PM
RE: Engine surges - by Oldman - 19-06-2023, 01:29 PM
RE: Engine surges - by Wattie - 20-06-2023, 10:59 AM
RE: Engine surges - by Barry - 20-06-2023, 12:30 PM
RE: Engine surges - by Barry - 20-06-2023, 12:55 PM
RE: Engine surges - by Barry - 30-06-2023, 09:19 AM
RE: Engine surges - by Barry - 12-08-2023, 09:16 AM
RE: Engine surges - by grumble - 12-08-2023, 04:48 PM
RE: Engine surges - by Grantus - 12-08-2023, 06:36 PM

Forum Jump:


Users browsing this thread: 3 Guest(s)