Accelerator Pedal - Printable Version +- Kombi Club Australia (https://kombiclubaustralia.com) +-- Forum: Kombi Club (https://kombiclubaustralia.com/forumdisplay.php?fid=1) +--- Forum: Resto Corner (https://kombiclubaustralia.com/forumdisplay.php?fid=31) +--- Thread: Accelerator Pedal (/showthread.php?tid=696) Pages:
1
2
|
Accelerator Pedal - Littleoak36 - 11-09-2023 Hi team 73 T2 Bay Accelerator pedal keeps slipping to the right when pressed. Any help or guidance please. RE: Accelerator Pedal - KIWI - 11-09-2023 (11-09-2023, 04:17 PM)Littleoak36 Wrote: Hi team Is the plate that attaches to the floor moving? Please post a picture of the back of the pedal as they differ by year. PR RE: Accelerator Pedal - Barry - 11-09-2023 Is there meant to be a circlip that holds the pin in? RE: Accelerator Pedal - Wayne Murray - 11-09-2023 Thought they had a spring clip hold the rod across the floor to the rod from the pedal. Does the rod from the pedal have a groove around it, about 3mm from the end. If so you need a spring clip, I can take a photo of the clip I’m talking about. There are a few different style pedal assembly’s. RE: Accelerator Pedal - Littleoak36 - 11-09-2023 Photos reverse RE: Accelerator Pedal - Littleoak36 - 11-09-2023 (11-09-2023, 05:14 PM)KIWI Wrote: Is the plate that attaches to the floor moving? The base is not moving but the pedal is, there is a small wire on reverse that has possibly broke or come lose? RE: Accelerator Pedal - Littleoak36 - 11-09-2023 (11-09-2023, 05:19 PM)Barry Wrote: Is there meant to be a circlip that holds the pin in?There is some wire on reverse that may have come lose ? RE: Accelerator Pedal - Littleoak36 - 11-09-2023 (11-09-2023, 06:52 PM)Wayne Murray Wrote: Thought they had a spring clip hold the rod across the floor to the rod from the pedal. Does the rod from the pedal have a groove around it, about 3mm from the end. If so you need a spring clip, I can take a photo of the clip I’m talking about. Pic below Yea there are small grooves on each end, something has clearly come loose but I’m not sure what? RE: Accelerator Pedal - Wayne Murray - 11-09-2023 (11-09-2023, 08:21 PM)Littleoak36 Wrote: Pic below I'll take a photo tomorrow of the clip that I think should be on the rod. Also to check the pin that hold the pedal to the floor plate either the pin is rusted or broken and also the bottom of the pedal curled section that holds the pin can starts to open up and the tension on the pedal to pin is lost. RE: Accelerator Pedal - KIWI - 12-09-2023 +1 Wayne The spring you refer to is probably the pedal return spring 211-721-549/A and can be seen in the correct position wrapped around the retaining pin. Looking at the photo, it appears that the pedal mount has broken? It also appears that the pedal may be missing the RHS curled section that Wayne is referring to? Note that the early retaining pins had a centre grove about 1cm long (211-721-629/A), but the later ones did not have the groove (211-721-629/A). PR |